![]() For oil treatment, you can crack an oil molecule with microwave. ![]() This should match your part origin on the machine.Other than that, I think IMS would probably like to sell you a post and code gen. Depending on the material youre drying and the processing requirements, the systems. I've tried using posts that come with Catia before(about R8)but it was hard to get the exact output I wanted.The reference machining axis under part operation is what describes the G54.etc. Make sure you are using IMS's inch pptable. Not knowing your experience and training with Catia it's kind of hard to find a starting place. Well firstly, there's a broad range of things that could be wrong. I was thinking that the post processor is assuming a metric coordinate value input and messing the coordinates up for the output but I don't know where the settings are for this aspect of the post processor.Any help would be greatly appreciated.RE: Catia NC code generation problems (Aerospace) 22 Aug 07 09:23. The NC code will load into Mach3 and run but because of the x,y values in the NC file, the tool is going around in a very small area around (x=0,y=0).I think my Catia Tools-Options-Output are set correctly to identify the IMS post processor.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |